REMOVAL
Removal / installation · Vehicles built from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY |
Detach the 4 clips.

Disconnect the connector and remove the integration control and panel assembly.
| 2. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
![]() ![]() |
Detach the 4 clips and remove the instrument panel finish panel end LH.
| 3. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION |
![]() ![]() |
Detach the 5 clips and remove the No. 2 instrument panel finish panel cushion.
| 4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
![]() ![]() |
Detach the 4 clips and remove the instrument panel finish panel end RH.
Disconnect the connector.
| 5. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION |
- HINT:
- Use the same procedure described for the No. 2 instrument panel finish panel cushion.
| 6. REMOVE FRONT CONSOLE UPPER PANEL GARNISH |
![]() ![]() |
Put protective tape around the front console upper panel garnish.
Text in Illustration *1
Protective Tape
Detach the 5 clips.
Disconnect the connectors and remove the front console upper panel garnish.
| 7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() ![]() |
for LHD:
Remove the screw.
Detach the 2 clips and 2 guides and remove the No. 1 instrument panel under cover.
for RHD:

Remove the screw.
Detach the 3 clips and 2 guides and remove the No. 1 instrument panel under cover.
| 8. REMOVE FRONT NO. 1 CONSOLE BOX INSERT |
![]() ![]() |
Detach the 2 clips and guide and remove the front No. 1 console box insert.
| 9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Remove the screw.
Detach the 3 clips and 2 guides and remove the No. 2 instrument panel under cover.


Text in Illustration *A
for LHD
*B
for RHD
| 10. REMOVE FRONT NO. 2 CONSOLE BOX INSERT |
![]() ![]() |
Detach the 2 clips and guide and remove the front No. 2 console box insert.
| 11. REMOVE UPPER CONSOLE PANEL |
![]() ![]() |
Remove the 2 screws.
Detach the 2 clips and remove the upper console panel.
Disconnect the connector and detach the clamp.

| 12. REMOVE REAR CONSOLE BOX ASSEMBLY |
![]() ![]() |
Remove the 2 screws, 2 bolts and rear console box.









