2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

B1579 Voice Recognition Microphone Disconnected

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The radio and display receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.
DTC Code
DTC Detection Condition
Trouble Area
B1579
Telephone microphone signal is lost.
  1. Radio and display receiver assembly
  2. Map light assembly
  3. Telephone microphone assembly
  4. Harness or connector

WIRING DIAGRAM

B360077E06

INSPECTION PROCEDURE


1. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

  1. E280108E17
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H51-18 (SGND) - Body ground
    Always
    Below 1 Ω
    H51-19 (MIN-) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H51-4 (MACC) - Body ground
    Engine switch on (ACC)
    4 to 6 V

    Text in Illustration 
    *a
    Component with harness connected
    (Radio and Display Receiver Assembly)



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY)
  1. Disconnect the H51 radio and display receiver assembly connector.

  1. Disconnect the W7 map light assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H51-4 (MACC) - W7-11 (MACC)
    Always
    Below 1 Ω
    H51-5 (MIN+) - W7-12 (MCO+)
    Always
    Below 1 Ω
    H51-19 (MIN-) - W7-13 (MCO-)
    Always
    Below 1 Ω
    H51-6 (SNS2) - W7-14 (SNS2)
    Always
    Below 1 Ω
    H51-4 (MACC) - Body ground
    Always
    10 kΩ or higher
    H51-5 (MIN+) - Body ground
    Always
    10 kΩ or higher
    H51-19 (MIN-) - Body ground
    Always
    10 kΩ or higher
    H51-18 (SGND) - Body ground
    Always
    10 kΩ or higher
    H51-6 (SNS2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK TELEPHONE MICROPHONE ASSEMBLY
  1. Replace the telephone microphone assembly with a known good one (Click here).

  1. Check for DTCs (Click here).

    OK:
    No DTCs are output.



NG
REPLACE MAP LIGHT ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)


← B1552 Extension Module Malfunction (+ B158A, B15B7) (from Aug 2014)B1579 Voice Recognition Microphone Disconnected (from Aug 2014) →