2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the following procedures to troubleshoot the wide view front monitor system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage with the engine switch off.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.

    NEXT

    3.CHECK NAVIGATION SYSTEM OR AUDIO AND VISUAL SYSTEM
    1. for Navigation Receiver Type:Refer to the navigation system (Click here).

    2. for Radio and Display Type:Refer to the audio and visual system (Click here).

      Result 
      Result
      Proceed to
      Navigation system or Audio and visual system is normal
      A
      Navigation system is abnormal (for Navigation Receiver Type)
      B
      Audio and visual system is abnormal (for Radio and Display Type)
      C


    B.

    C.
    A

    4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the GTS to check if the CAN communication system is functioning normally.

      1. for LHD with Entry and Start System: Click here
      2. for LHD without Entry and Start System: Click here
      3. for RHD with Entry and Start System: Click here
      4. for RHD without Entry and Start System: Click here
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output (for LHD with Entry and Start System)
      B
      CAN DTC is output (for LHD without Entry and Start System)
      C
      CAN DTC is output (for RHD with Entry and Start System)
      D
      CAN DTC is output (for RHD without Entry and Start System)
      E


    B.

    C.

    D.

    E.
    A

    5.CHECK DTC OUTPUT*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests (Click here).

      NOTICE:
      The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.
      System
      Proceed to
      Parking Assist Monitor System
      Click here
      Side Monitor System
      Click here

      Result 
      Result
      Proceed to
      No DTC is output
      A
      DTC is output
      B


    B.
    A

    6.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    7.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).

    NEXT

    8.ADJUST, REPAIR OR REPLACE
      NEXT

      9.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)PROBLEM SYMPTOMS TABLE (Aug 2013 – Jul 2014) →