CUSTOMIZE PARAMETERS
Removal / installation · Vehicles built from Aug 2013
| 1. CUSTOMIZE METER / GAUGE SYSTEM |
Customizing with the intelligent tester
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the intelligent tester on.
Enter the following menus: Customize Setting / Warning or Display.
Select the setting by referring to the table below.
Warning Display
Default
Content
Setting
Relevant ECU
Driver Side Seatbelt Warning Buzzer*
ON
Function to turn on/off the seat belt warning buzzer
ON or OFF
Combination meter assembly
Front Passenger Side Seatbelt Warning Buzzer*
ON
Function to turn on/off the seat belt warning buzzer
ON or OFF
Combination meter assembly
- *: This setting is only valid for the buzzer which sounds at 20 km/h (12 mph) or more
Display Display
Default
Content
Setting
Relevant ECU
Units By Region*1, *2
Units of Destination
Function to change the unit of the display
Km/l JP, Km/l, Mi/g US or Mi/g UK
Combination meter assembly
Language*1, *2
Language of Destination
Function to change the language of the display
Eng US, Eng UK, French, German, Spanish, Italian, Japanese, CHN Sim, CHN Trd or Russian
Combination meter assembly
ECO Drive Indicator*3
ON
Function to enable or disable eco driving indicator zone display in the multi-information display
ON or OFF
Combination meter assembly
- *1: for Analog Meter
- *2: except 5L-E
- *3: for Automatic Transmission
- *: This setting is only valid for the buzzer which sounds at 20 km/h (12 mph) or more
