2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

CUSTOMIZE PARAMETERS

Removal / installation · Vehicles built from Aug 2013


1. CUSTOMIZE AIR CONDITIONING SYSTEM

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Record the current settings before customizing.

  1. Customizing with intelligent tester.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Air Conditioner / Utility / Customize.

    5. Select the setting by referring to the table below.

      Air Conditioner 
      Display
      Default
      Contents
      Setting
      Set Temperature Shift
      Normal
      Function to set the temperature shift.
      +2 C, +1 C, Normal, -1 C or -2 C
      Compressor Mode
      Automatic
      Function to turn the A/C on automatically by pressing the AUTO button when the blower is on and the A/C is off.
      Automatic or Manual
      Air Inlet Mode
      Automatic
      Function to automatically change to recirculation mode when the A/C is turned on.
      Automatic or Manual
      Foot/DEF Auto Mode
      ON
      Function to turn on the airflow from the front and rear footwell register ducts and front defroster automatically when auto mode is on.
      ON or OFF
      Foot/DEF Automatic Blow Up Function
      ON
      Function to change the blower level automatically when the front defroster is on.
      ON or OFF
      Add Foot Air in FACE Mode
      ON
      When the FACE mode is selected, an additional amount of air is blown to the foot area.
      ON or OFF

  1. Customizing with Multi-display

    1. Turn the engine switch on (IG).

    2. Select the following menus: Setup / Vehicle / Vehicle Customization.

    3. Select the setting by referring to the table below.

      Climate Settings 
      Display
      Default
      Content
      Setting
      Relevant ECU
      Smog Sensor Sensitivity
      0
      (middle bar)
      Function to change the sensitivity of the exhaust gas sensor.
      +3, +2, +1, 0, -1, -2 or -3
      Air conditioning amplifier assembly
      Auto A/C Mode
      On
      Function to turn the A/C on automatically by pressing the AUTO button when the blower is on and the A/C is off.
      On or Off
      Air conditioning amplifier assembly

← HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2014)PROBLEM SYMPTOMS TABLE (Aug 2013 – Jul 2014) →