2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use these procedures to troubleshoot the air conditioning system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
      NEXT

      3.INSPECT BATTERY VOLTAGE
      1. Measure the voltage of the battery.

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      NEXT

      4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
      1. Use the intelligent tester to check if the CAN communication system is functioning normally.

        Result 
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output (for LHD with Entry and Start System)
        B
        CAN DTC is output (for LHD without Entry and Start System)
        C
        CAN DTC is output (for RHD with Entry and Start System)
        D
        CAN DTC is output (for RHD without Entry and Start System)
        E


      B.

      C.

      D.

      E.
      A

      5.CHECK PANEL DIAGNOSIS
      1. Check panel diagnosis (Click here).

        1. Indicator Check

        2. Sensor Check

      NEXT

      6.CHECK FOR DTC*
      1. Check for DTCs and note any codes that are output (Click here).

      2. Clear the DTCs (Click here).

      3. Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the conditions indicated by the DTC. Then recheck for DTCs.

        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      A

      7.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      A

      8.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Terminals of ECU (Click here)

      2. Data List / Active Test (Click here)

      3. On-vehicle Inspection

      4. Inspection

      NEXT

      9.ADJUST, REPAIR OR REPLACE
        NEXT

        10.CONFIRMATION TEST
          NEXT

          ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)CUSTOMIZE PARAMETERS (from Aug 2013) →