2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Display Signal Circuit between Radio Receiver and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E286235E04

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the H51 radio and display receiver assembly connector.

  1. Disconnect the H68 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H51-13 (VV+) - H68-6 (VV+)
    Always
    Below 1 Ω
    H51-14 (VV-) - H68-11 (VV-)
    Always
    Below 1 Ω
    H51-13 (VV+) - Body ground
    Always
    10 kΩ or higher
    H51-14 (VV-) - Body ground
    Always
    10 kΩ or higher
    H51-12 (SG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Display Signal Circuit between Radio Receiver and Stereo Jack Adapter (Aug 2013 – Jul 2014)Radio Receiver Power Source Circuit (Aug 2013 – Jul 2014) →