REMOVAL
Removal / installation · Vehicles built from Aug 2013
| 1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY |
Detach the 4 clips.

Disconnect the connector and remove the integration control and panel assembly.
| 2. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
![]() ![]() |
Detach the 4 clips and remove the instrument panel finish panel end LH.
| 3. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
![]() ![]() |
Detach the 4 clips and remove the instrument panel finish panel end RH.
| 4. REMOVE FRONT CONSOLE UPPER PANEL GARNISH |
w/o Seat Heater System:
Put protective tape around the front console upper panel garnish.

Text in Illustration *1
Protective Tape
Detach the 5 clips and remove the front console upper panel garnish.
Disconnect the connector.
w/o CRAWL:
Put protective tape around the front console upper panel garnish.

Text in Illustration *1
Protective Tape
Detach the 5 clips and remove the front console upper panel garnish.
Disconnect each connector.
w/ CRAWL:
Put protective tape around the front console upper panel garnish.

Text in Illustration *1
Protective Tape
Detach the 5 clips and remove the front console upper panel garnish.
| 5. REMOVE COMBINATION SWITCH |
Remove the 2 bolts.

Detach the 3 clamps and remove the center cluster module switch.
Disconnect the connector.
| 6. REMOVE CENTER CLUSTER MODULE SWITCH (MULTI-TERRAIN SELECT SWITCH) |
Remove the 4 screws and center cluster module panel from the center cluster module switch.



