2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Due to this, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM

E245681E41

INSPECTION PROCEDURE

HINT:
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).


1. CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY

  1. E225824E52
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H63-1 (MUTE) - Body ground
    Ignition switch ACC, audio system playing → audio system changing modes
    2.0 V or higher → Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Stereo Component Amplifier Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the H51 radio and display receiver assembly connector.

  1. Disconnect the H63 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H51-16 (MUT1) - H63-1 (MUTE)
    Always
    Below 1 Ω
    H51-16 (MUT1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)

  1. E265411E05
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H51-16 (MUT1) - Body ground
    Ignition switch ACC, audio system playing
    2.0 V or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Radio and Display Receiver Assembly)



NG
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)


← Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier (Aug 2013 – Jul 2014)AVC-LAN Circuit (Aug 2013 – Jul 2014) →