Vehicle Speed Signal Circuit between Radio Receiver and Extension Module
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The navigation ECU receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna assembly, and then adjusts vehicle position.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU) |
Disconnect the z12 radio and display receiver assembly connector.
Disconnect the z13 navigation ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
z12-2 (SPDO) - z13-5 (SPD)
Always
Below 1 Ω
z12-2 (SPDO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
