2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Vehicle Speed Signal Circuit between Radio Receiver and Extension Module

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The navigation ECU receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna assembly, and then adjusts vehicle position.

WIRING DIAGRAM

E261261E35

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
  1. Disconnect the z12 radio and display receiver assembly connector.

  1. Disconnect the z13 navigation ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    z12-2 (SPDO) - z13-5 (SPD)
    Always
    Below 1 Ω
    z12-2 (SPDO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Vehicle Speed Signal Circuit between Radio Receiver and Extension Module (Aug 2013 – Jul 2014)Reverse Signal Circuit (Aug 2013 – Jul 2014) →