Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR
RM27T0E _51 Engine / Hybrid System _053656 2TR-FE ENGINE CONTROL _0260414 AIR FUEL RATIO SENSOR A

2TR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (See page Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (See page Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).


a.
A355801E02
1.563,1.406 1.802,1.875 1.802,1.875 1.906,1.875 false 1.281,0.625 1.479,0.792 0.198,0.167 10 true *a 1.927,1.781 2.25,1.969 0.323,0.188 10 true SST

Using SST, install the air fuel ratio sensor.

SST
09224-00011  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

Text in Illustration
*a Fulcrum Length

HINT:
·

Make sure SST and the wrench are connected in a straight line.

·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 38 N*m (384 kgf*cm, 28 ft.*lbf)




b.

Attach the wire harness clamp.


c.

Connect the air fuel ratio sensor connector.


Hide 53736B 2.INSTALL FRONT NO. 1 FENDER APRON TO FRAME SEAL RH