Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › SFI SYSTEM › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053656 2TR-FE ENGINE CONTROL _0260420 SFI SYSTEM L

2TR-FE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


INITIALIZATION


NOTICE:
·

Perform initialization (throttle position) after replacing or cleaning the throttle body with motor assembly.

(See page Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>THROTTLE BODY>INSTALLATION)

·

Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM.

(See page Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>THROTTLE BODY>INSTALLATION)

·

Perform Registration (VIN registration) when replacing the ECM.

(See page Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION)

·

If the ECM is replaced, register the ECU communication ID for Engine Immobiliser System.

(refer to the Service Bulletin for registration).



HINT:

Initialization cannot be completed by only removing the battery.



DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

(See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)

·

When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

(See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)




FOR USING GTS


CAUTION:

Observe the following items for safety reasons:

-

Read its instruction books before using the GTS.

-

Prevent the GTS cable from being caught on the pedals, shift lever and steering wheel when driving with the GTS connected to the vehicle.

-

When driving the vehicle for testing purposes using the GTS, two persons are required. One drives the vehicle and the other operates the GTS.





EXPRESSION OF IGNITION SWITCH


HINT:

The type of ignition switch used on this model differs according to the specifications of the vehicle.

The expressions listed in the table below are used in this section.


Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off Off Off
Ignition Switch ON ON On (IG)
Ignition Switch ACC ACC On (ACC)
Engine Start START Start