Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › THROTTLE BODY
RM27T0E _51 Engine / Hybrid System _053657 1GR-FE ENGINE CONTROL _0260423 THROTTLE BODY A

1GR-FE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

for Automatic Transmission:

Perform "Inspection After Repairs" after replacing the throttle body with motor assembly (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).


PROCEDURE

Hide 22030 1.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

HINT:

for Automatic Transmission:

Perform "Inspection After Repairs" after replacing the throttle body with motor assembly (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).


a.

Install a new gasket and the throttle body with motor with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the throttle position sensor and throttle control motor connector.


c.

Connect the No. 4 water by-pass hose.


d.

Connect the No. 5 water by-pass hose.


Hide 51405A 5.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 9.PERFORM INITIALIZATION

NOTICE:

Perform the following procedure after replacing the throttle body with motor assembly or any throttle body components. The following procedure should also be performed if the throttle body with motor assembly is cleaned.


a.

for Manual Transmission:

Disconnect the EFI and ETCS fuses at the same time. Wait at least 60 seconds, and then reconnect the fuses.


b.

Turn the engine switch on (IG) without operating the accelerator pedal.

NOTICE:

If the accelerator pedal is operated, perform the above steps again.



c.

Connect the intelligent tester to the DLC3 and clear the DTCs (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR).


d.

for Automatic Transmission:

Perform "Inspection After Repairs" (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).


e.

Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

Standard idle speed:

690 to 790 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in neutral.




f.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.


g.

Perform a road test and confirm that there are no abnormalities.