for Automatic Transmission:
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).
1.INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
for Automatic Transmission:
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).
Using SST, install the sensor.
| *a | Fulcrum Length |
Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Make sure SST and the wrench are connected in a straight line.
89467B
2.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
for Automatic Transmission:
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).
Using SST, install the sensor.
| *a | Fulcrum Length |
Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Make sure SST and the wrench are connected in a straight line.
3.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY
Install the exhaust manifold (See page Engine / Hybrid System>1GR-FE (INTAKE / EXHAUST)>EXHAUST MANIFOLD>INSTALLATION).