The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. The skid control ECU converts these wheel speed signals into a 4-pulse signal and outputs it to the ECM via the combination meter assembly. The ECM determines the vehicle speed based on the frequency of this pulse signal.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0500 | While the vehicle is being driven, no vehicle speed sensor signal is transmitted to the ECM (2 trip detection logic). | ·
Open or short in speed signal circuit ·
Combination meter assembly ·
ECM |
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Drive the vehicle and check whether the operation of the speedometer in the combination meter assembly is normal.
The vehicle speed sensor is operating normally if the speedometer reading is normal.
If the speedometer does not operate, check it by following the procedure described in Speedometer Malfunction (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>Speedometer Malfunction).
OK
NG
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Vehicle Speed.
Drive the vehicle.
Read the value displayed on the GTS.
Vehicle speeds displayed on GTS and speedometer display are equal.
OK
NG
Disconnect the combination meter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G6-32 (+S) - Body ground | Engine switch on (IG) | 4.5 to 5.5 V |
| *a | Front view of wire harness connector
(to combination meter assembly) |
Reconnect the combination meter assembly connector.
OK
NG
Move the shift lever to N.
Jack up the vehicle.
Check the voltage between the terminal of the combination meter assembly and the body ground while a wheel is turned slowly.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G6-32 (+S) - Body ground | Engine switch on (IG) | Voltage generated intermittently |
| *a | Component with harness connected
(combination meter assembly) |
The output voltage should fluctuate up and down, similarly to the diagram, when a wheel is turned slowly.
OK
NG
Disconnect the combination meter assembly connector.
Disconnect the ECM connector.
Measure the resistance according the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G6-32 (+S) - G56-12 (SPD) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G6-32 (+S) - G55-18 (SPD) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G6-32 (+S) or G56-12 (SPD) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G6-32 (+S) or G55-18 (SPD) - Body ground | Always | 10 kΩ or higher |
Reconnect the combination meter assembly connector.
Reconnect the ECM connector.
OK
NG