Home › Engine / Hybrid System › 5L-E (ENGINE CONTROL) › ACCELERATOR PEDAL
RM27T0E _51 Engine / Hybrid System _053658 5L-E ENGINE CONTROL _0260439 ACCELERATOR PEDAL G

5L-E ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Inspect the voltage.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester main switch on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / Accelerator Pos No. 1, Accelerator Pos No. 2.


v.

When depressing and releasing the accelerator pedal, check that the values of the accelerator pos No. 1 and accelerator pos No. 2 are within the specified range.

Accelerator Pos No. 1 Standard Voltage:
Condition Specified Condition
Accelerator pedal is released 0.4 to 1.4 V
Accelerator pedal is depressed 3.0 to 4.6 V


Accelerator Pos No. 2 Standard Voltage:
Condition Specified Condition
Accelerator pedal is released 0.9 to 2.3 V
Accelerator pedal is depressed 3.4 to 5.5 V


If the result is not as specified, check the accelerator pedal, wire harness and ECM.