5L-E (ENGINE CONTROL)
ECD SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- HOW TO PROCEED WITH TROUBLESHOOTING
- CHECK FOR INTERMITTENT PROBLEMS
- BASIC INSPECTION
- REGISTRATION
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECM
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FREEZE FRAME DATA
- CHECK MODE PROCEDURE
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- VEHICLE CONTROL HISTORY from 2017.08
- P0105 Open or short in manifold absolute pressure sensor circuit for 2 seconds or more.
- P0115 Open or short in engine coolant temperature sensor circuit for 0.5 seconds or more.
- P0180 Open or short in fuel temperature sensor circuit for 0.5 seconds or more.
- P0335 No NE signal to ECM for 0.5 seconds or more at 680 rpm or more.
- P0340 No TDC signal to ECM at 400 rpm or more.
- P0500 All conditions below are detected continuously for 8 second or more: 1. No speed signal is input to the ECM....
- P0630 Either condition is met (1 trip detection logic): · VIN is not stored in the ECM. · Input VIN is incorrect.
- P1115 Open or short in intake air temperature sensor circuit for 0.5 seconds or more.
- P1120 Condition (a), (b), (c) or (d) continues for 2.0 seconds: (a) VPA is 0.2 V or less and VPA2 is 0.5 V or less....
- P1121 Either of the ECM sensors have completed learning and the electric potential difference of VPA and VPA2...
- P1220 During and after engine warm up, actual injection timing is different from target value of ECM calculated for...
- P1222 Open or short in throttle control motor circuit.
- P1225 Open or short in spill control valve at 500 rpm or more.
- P1520 Conditions (a), (b) and (c) continue for 0.5 seconds or more(1 trip detection logic): (a) Ignition switch is...
- P1611 ECU malfunction
- P1670 When the ignition switch was turned ON, or when the ECM determines whether it is an error of RAM in ECM or...
- Pre-heating Control Circuit
- ECM Power Source Circuit
- VC Output Circuit
- Starter Signal Circuit
- Air Conditioning Signal Circuit
- Air Conditioning Cut Control Circuit
- Brake Override System
- MIL Circuit