Home › Engine / Hybrid System › 1KD-FTV (ENGINE CONTROL) › ECD SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053659 1KD-FTV ENGINE CONTROL _0260458 ECD SYSTEM J

1KD-FTV ENGINE CONTROL  ECD SYSTEM  Starter Signal Circuit  


DESCRIPTION

While the engine is being cranked, current flows from terminal ST1 of the ignition switch assembly*1 or terminal STAR of the power management control ECU*2 to the park/neutral position switch assembly*3 or clutch pedal switch assembly (for Clutch Start System)*4 and also flows to terminal STA of the ECM (STA Signal).

*1: w/o Entry and Start System

*2: w/ Entry and Start System

*3: for Automatic Transmission

*4: for Manual Transmission

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses of circuits related to this system before performing the following inspection procedure.

·

After replacing the ECM, the new ECM needs registration (See page Engine / Hybrid System>1KD-FTV (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (See page Engine / Hybrid System>1KD-FTV (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).



HINT:

This chart is based on the premise that the engine can crank normally. If the engine cannot crank normally, proceed to Problem Symptoms Table (See page Engine / Hybrid System>1KD-FTV (ENGINE CONTROL)>ECD SYSTEM>PROBLEM SYMPTOMS TABLE).


PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.


e.

Read the value.

OK:
Ignition Switch Condition Starter Signal
ON OFF
START ON




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (STARTER RELAY (ST) - ECM)
2.CHECK HARNESS AND CONNECTOR (STARTER RELAY (ST) - ECM)
a.

Remove the ST relay from the engine room relay block.


b.

Disconnect the ECM connectors.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
ST relay terminal 2 - G57-6 (STA) Always Below 1 Ω
ST relay terminal 2 or G57-6 (STA) - Body ground Always 10 kΩ or higher



d.

Reinstall the starter relay (ST).


e.

Reconnect the ECM connectors.



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (STARTER RELAY (ST) - ECM)