Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260465 CAMSHAFT POSITION SENSOR A

1GD-FTV ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CAMSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.


b.

Install the camshaft position sensor with the bolt to the cylinder head cover sub-assembly.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

When reusing the camshaft position sensor, check the O-rings.

·

Make sure that the O-ring is not cracked or jammed when installing it on the cylinder head cover sub-assembly.

·

Replace with a new part if it is dropped or if it receives a strong impact.




c.

Connect the camshaft position sensor connector.