Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › POWER STEERING OIL PRESSURE SWITCH › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260471 POWER STEERING OIL PRESSURE SWITCH A

1GD-FTV ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 89438B 1.INSTALL POWER STEERING OIL PRESSURE SWITCH

a.

Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.


b.

Using a 19 mm deep socket wrench, install the power steering oil pressure switch.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (the surface that contacts the pressure feed tube).

·

Be careful not to damage the O-ring when installing the power steering oil pressure switch.




c.

Connect the power steering oil pressure switch connector.


Hide 2.ADD POWER STEERING FLUID

Hide 4.CHECK FOR POWER STEERING FLUID LEAK