1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
22030
4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
23271F
5.DISCONNECT FUEL HOSE
23273C
6.DISCONNECT NO. 2 FUEL HOSE
Slide the clamp and disconnect the No. 2 fuel hose.
23270
7.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY
23814B
8.REMOVE FUEL DELIVERY PIPE WITH FUEL INJECTOR
Disconnect the 4 fuel injector assembly connectors.
Disconnect the purge VSV connector.
Detach the wire harness clamp.
Remove the bolt and disconnect the wire harness clamp bracket.
Remove the bolt and disconnect the purge VSV.
Remove the 2 bolts and fuel delivery pipe together with the fuel injectors.
Be careful not to drop the fuel injectors when removing the fuel delivery pipe.
Remove the 2 No. 1 delivery pipe spacers.
| *a | Protective Tape |
Remove the 4 injector vibration insulators.
Using a screwdriver, remove the 4 spacers.
Tape the screwdriver tip before use.
23250
9.REMOVE FUEL INJECTOR ASSEMBLY
Remove the 4 fuel injector assemblies from the fuel delivery pipe.
|
Pull Out |
Remove the 4 O-rings from the 4 fuel injector assemblies.
| *a | O-ring |