Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL PUMP (for Single Tank Type)
RM27T0E _51 Engine / Hybrid System _053667 1GR-FE FUEL _0260552 FUEL PUMP(for Single Tank Type) G

1GR-FE FUEL  FUEL PUMP(for Single Tank Type)  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP

a.

Inspect the resistance of the fuel pump.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.
A223267E01
0.019,0.011 0.212,0.157 0.193,0.147 10 *a 0.697,0.84 0.821,0.984 0.123,0.144 10 2 1.41,0.931 0.846,0.931 false 2.671,0.842 2.795,0.987 0.123,0.144 10 1 2.638,0.929 2.074,0.929 false

Inspect the operation of the fuel pump.

i.

Connect the positive (+) lead of the battery to terminal 1 of the connector and the negative (-) lead to terminal 2. Check that the fuel pump operates.

Text in Illustration
*a Component without harness connected
(Fuel Pump)

If the result is not as specified, replace the fuel pump and fuel pump ECU.

NOTICE:
·

These tests must be performed within 10 seconds to prevent the coil from burning out.


·

Keep the fuel pump as far away from the battery as possible.


·

Always turn the voltage on and off on the battery side, not the fuel pump side.

·

When the pump is locked and does not operate due to foreign matter being stuck, etc., replace the fuel pump ECU (See page Engine / Hybrid System>1GR-FE (FUEL)>FUEL PUMP ECU>REMOVAL) together with the fuel pump, as the fuel pump ECU may be damaged electrically.