Home › Engine / Hybrid System › 5L-E (FUEL) › FUEL FILTER
RM27T0E _51 Engine / Hybrid System _053668 5L-E FUEL _0260560 FUEL FILTER A

5L-E FUEL  FUEL FILTER  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

When replacing the filter, use TOYOTA genuine parts or equivalent parts.


PROCEDURE

Hide 23300J 1.REMOVE FUEL FILTER ASSEMBLY

a.
A223871

Disconnect the 2 fuel hoses.


b.

Disconnect the level warning switch connector.


c.

Remove the 2 nuts and fuel filter.


Hide 2.DRAIN FUEL

a.
A225894

Loosen the fuel filter drain plug and drain the fuel from the fuel filter.


Hide 23382 3.REMOVE FUEL FILTER CASE

a.
A225895

Detach the level warning switch connector clamp from the fuel filter cap.


b.

Remove the 2 bolts, fuel filter case and fuel filter gasket.


Hide 23390 5.REMOVE FUEL FILTER ELEMENT ASSEMBLY

a.
A223876

Using SST, remove the fuel filter element.

SST
09228-64010  


Hide 23390 6.INSTALL FUEL FILTER ELEMENT ASSEMBLY

a.

Check and clean the installation surface of the fuel filter element.


b.

Apply fuel to the gasket of a new fuel filter element.


c.

Lightly screw the fuel filter element into place, and tighten it until the gasket comes into contact with the seat.


d.
A223231

Tighten the fuel filter element an additional 3/4 turn by hand.


Hide 23382 8.INSTALL FUEL FILTER CASE

a.

Install the fuel filter gasket and fuel filter case to the fuel filter element.


b.
A223873E02
2.689,0.738 2.903,0.898 0.214,0.161 10 *b 0.505,0.911 0.672,1.071 0.167,0.161 10 *a

Tighten the 2 bolts.

Torque:
3.4 N*m (35 kgf*cm, 30 in.*lbf)

HINT:

Install the level warning switch within the angle range shown in the illustration.



c.

Attach the level warning switch connector clamp to the fuel filter cap.

Text in Illustration
*a Front
*b 0 to 20°


Hide 23300J 9.INSTALL FUEL FILTER ASSEMBLY

a.

Install the fuel filter with the 2 nuts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


b.
A223872E01
2.485,2.664 2.669,2.820 0.184,0.156 10 *a 2.441,2.995 2.837,3.143 0.395,0.148 10 120° 0.343,2.659 1.929,2.810 1.586,0.151 10 0 to 3 mm (0 to 0.118 in.) 0.322,4.129 2.430,4.273 2.108,0.144 10 2 to 7 mm (0.0787 to 0.276 in.)

Connect the level warning switch connector.


c.

Connect the 2 fuel hoses.

Text in Illustration
*a Upper


Hide 10.BLEED AIR FROM FUEL SYSTEM

a.
A225897

Using the hand pump mounted on the fuel filter cap, bleed the air from the fuel system. Continue pumping until the pump resistance increases.