Home › Engine / Hybrid System › 1GD-FTV (FUEL) › COMMON RAIL › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053670 1GD-FTV FUEL _0260592 COMMON RAIL A

1GD-FTV FUEL  COMMON RAIL  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the parts in the following chart (A), replace the No. 1 injection pipe subassembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

Replaced Parts (A) Pipes Requiring New Replacement
Injector assembly (including shuffling the injector assemblies between the cylinders)
·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly


Supply pump assembly Fuel inlet pipe sub-assembly
·

Common rail assembly

·

Cylinder block sub-assembly

·

Cylinder head sub-assembly

·

Cylinder head gasket

·

Timing chain case assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly

·

Fuel inlet pipe sub-assembly



·

After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly, clean them with a brush and compressed air.

·

The common rail assembly is a precision instrument. Do not use the common rail assembly if it is struck or dropped.

·

Hold the common rail assembly itself during removal and installation. Do not hold the pressure discharge valve or fuel pressure sensor, etc.

·

Make sure foreign matter does not enter the fuel path.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)


Hide 25800 3.REMOVE EGR COOLER ASSEMBLY

Hide 23804D 5.REMOVE NO. 4 FUEL PIPE SUB-ASSEMBLY

Hide 23804C 7.REMOVE FUEL INLET PIPE SUB-ASSEMBLY

Hide 8.REMOVE WIRING HARNESS CLAMP BRACKET

Hide 9.REMOVE NO. 1 AND NO. 2 INJECTION PIPE SUB-ASSEMBLY

Hide 23282D 10.REMOVE NO. 4 FUEL HOSE

a.
A344943

Slide the clamp and disconnect the No. 4 fuel hose from the common rail assembly.


Hide 23810A 11.REMOVE COMMON RAIL ASSEMBLY

a.
A344944

Detach the wire harness clamp.


b.

Disconnect the fuel pressure sensor connector from the common rail assembly.


c.

Remove the 2 nuts and common rail assembly.

NOTICE:

Do not remove the pressure discharge valve or fuel pressure sensor.