Home › Engine / Hybrid System › 2TR-FE (INTAKE / EXHAUST) › EXHAUST MANIFOLD
RM27T0E _51 Engine / Hybrid System _053676 2TR-FE INTAKE / EXHAUST _0260635 EXHAUST MANIFOLD A

2TR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 53736 1.REMOVE FRONT FENDER APRON SEAL RH

a.
C214927

Remove the 5 clips and front fender apron seal RH.


Hide 53736B 2.REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL RH

a.
C214928

Remove the 5 clips and front No. 1 fender apron to frame seal RH.


Hide 25710 3.REMOVE AIR SWITCHING VALVE ASSEMBLY

Hide 17410 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Disconnect the air fuel ratio sensor connector and detach the wire harness clamp.


b.

Disconnect the heated oxygen sensor connector and detach the wire harness clamp.


c.

Remove the 4 bolts and 2 compression springs.


d.

Disconnect the exhaust pipe support to remove the front exhaust pipe assembly.


e.

Remove the 2 gaskets.


Hide 17118 5.REMOVE MANIFOLD STAY

a.
C214941

Remove the 3 bolts and manifold stay.


Hide 17141 6.REMOVE EXHAUST MANIFOLD

a.
A350559

Remove the 8 nuts and exhaust manifold.


b.

Remove the gasket.