Home › Engine / Hybrid System › 2TR-FE (INTAKE / EXHAUST) › EXHAUST PIPE
RM27T0E _51 Engine / Hybrid System _053676 2TR-FE INTAKE / EXHAUST _0260636 EXHAUST PIPE A

2TR-FE INTAKE / EXHAUST  EXHAUST PIPE  INSTALLATION  


PROCEDURE

Hide 17410 1.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.
A107610

Using a vernier caliper, measure the free length of the compression spring.

Minimum free length:

41.5 mm (1.63 in.)


If the length is less than the minimum, replace the compression spring.


b.
A076194E27
2.031,1.583 1.5,1.708 false 1.5,1.708 1.354,1.708 false 2.438,0.979 3.042,0.979 false 1.156,1.625 1.375,1.802 0.219,0.177 10 false *1 3.063,0.885 3.281,1.063 0.219,0.177 10 false *a

Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with the exhaust manifold.

Text in Illustration
*1 Gasket
*a Wooden Block

NOTICE:
·

Be sure to install the gasket so that it faces the correct direction.

·

Do not reuse the gasket.

·

Do not damage the gasket.

·

When connecting the front exhaust pipe assembly, do not push in the gasket with the front exhaust pipe assembly.




c.

Connect the front exhaust pipe assembly to the exhaust pipe support.


d.

Install the front exhaust pipe assembly to the exhaust manifold with the 2 compression springs and 2 bolts. Alternately tighten the bolts in several passes.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 17420 4.INSTALL CENTER EXHAUST PIPE ASSEMBLY

a.

Install a new gasket.


b.

Connect the center exhaust pipe assembly to the 2 exhaust pipe supports.


c.

Install the center exhaust pipe assembly to the front exhaust pipe assembly with the 2 bolts. Alternately tighten the bolts in several passes.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)


Hide 17430 5.INSTALL TAILPIPE ASSEMBLY

a.

Install a new gasket.


b.

Connect the tailpipe assembly to the exhaust pipe support.


c.

Install the tailpipe assembly to the center exhaust pipe assembly with the 2 bolts. Alternately tighten the bolts in several passes.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)


Hide 6.CHECK FOR EXHAUST GAS LEAK

If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.

HINT:

If an exhaust gas leak has been repaired, perform an inspection following the repair (See page Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).