Home › Engine / Hybrid System › 1GD-FTV (COOLING) › WATER PUMP › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053685 1GD-FTV COOLING _0260678 WATER PUMP A

1GD-FTV COOLING  WATER PUMP  INSTALLATION  


PROCEDURE

Hide 16100 1.INSTALL ENGINE WATER PUMP ASSEMBLY

a.
U169471E02
2.875,0.458 3.042,0.625 0.167,0.167 10 false 1 2.635,1.833 2.802,2 0.167,0.167 10 false 6 2.094,1.833 2.26,2 0.167,0.167 10 false 7 1.802,1.969 1.969,2.135 0.167,0.167 10 false 8 0.406,1.979 0.573,2.146 0.167,0.167 10 false 2 0.615,1.135 0.781,1.302 0.167,0.167 10 false 3 0.688,0.302 0.854,0.469 0.167,0.167 10 false 4 2.167,0.375 2.333,0.542 0.167,0.167 10 false 5

Temporarily install a new gasket and the engine water pump assembly with the 8 bolts.

Standard length:
Item Length
Bolt A 45 mm (1.77 in.)
Bolt B 65 mm (2.56 in.)


Text in Illustration
V100135

Bolt A
V100136

Bolt B


b.

Tighten the 8 bolts in the order shown in the illustration.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 16284 2.CONNECT NO. 1 TURBO WATER HOSE

a.

Connect the No. 1 turbo water hose to the engine water pump assembly and slide the hose clamp to secure the hose.


Hide 16268 3.CONNECT NO. 1 WATER BY-PASS PIPE

a.
A343595E02
1.833,1.469 2.146,1.469 false 2.167,1.344 2.354,1.521 0.188,0.177 10 false *a

Install a new gasket to the No. 1 water by-pass pipe as shown in the illustration.

Text in Illustration
*a Claw

HINT:

Make sure that the claws of the gasket are facing the No. 1 water by-pass pipe.



b.

Connect the No. 1 water by-pass pipe to the engine water pump assembly with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Attach the wire harness clamp and connect the 2 connectors to the turbocharger sub-assembly.