11363A
1.INSTALL FLYWHEEL HOUSING SIDE COVER
28100
2.INSTALL STARTER ASSEMBLY
Install the starter assembly with the 2 bolts.
Connect the starter wire with the bolt and nut.
Close the terminal cap.
Connect the starter connector.
Connect the ground wire with the bolt.
28192
3.INSTALL STARTER COVER
Install the starter cover with the 3 bolts.
17105
4.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH
Install the exhaust manifold sub-assembly LH (See page Engine / Hybrid System>1GR-FE (INTAKE / EXHAUST)>EXHAUST MANIFOLD>INSTALLATION).
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).