Home › Engine / Hybrid System › 1GR-FE (STARTING) › STARTER › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053692 1GR-FE STARTING _0260717 STARTER A

1GR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 17105 2.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

a.

Remove the exhaust manifold sub-assembly LH (See page Engine / Hybrid System>1GR-FE (INTAKE / EXHAUST)>EXHAUST MANIFOLD>REMOVAL).


Hide 28192 3.REMOVE STARTER COVER

a.
A222904

Remove the 3 bolts and starter cover.


Hide 28100 4.REMOVE STARTER ASSEMBLY

a.
A222905

Remove the bolt and disconnect the ground wire.


b.

Disconnect the starter connector.


c.

Open the terminal cap.


d.

Remove the nut and bolt, and then disconnect the starter wire.


e.
A218197

Remove the 2 bolts and starter assembly.


Hide 11363A 5.REMOVE FLYWHEEL HOUSING SIDE COVER

A222907