53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
11259
2.REMOVE V-BANK COVER
3.REMOVE AIR CLEANER CAP AND HOSE
4.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
53737B
5.REMOVE FRONT FENDER APRON SEAL LH
w/ KDSS:
Remove the 7 clips and fender apron seal.
w/o KDSS:
Remove the 5 clips and fender apron seal.
53736
6.REMOVE FRONT FENDER APRON SEAL RH
Remove the 4 clips and fender apron seal.
53737A
7.REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL LH
Remove the 5 clips and frame seal.
53736B
8.REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL RH
Remove the 5 clips and fender apron seal.
17410
9.REMOVE FRONT EXHAUST PIPE ASSEMBLY
Remove the front exhaust pipe (See page Engine / Hybrid System>1GR-FE (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL).
17118
10.REMOVE MANIFOLD STAY
Remove the 3 bolts and manifold stay.
17361
11.REMOVE AIR TUBE (w/ Secondary Air Injection System)
45203
12.DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY (for RHD)
for Manual Tilt and Manual Telescopic Steering Column:
Disconnect the No. 2 steering intermediate shaft (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)>REMOVAL).
for Power Tilt and Power Telescopic Steering Column:
Disconnect the No. 2 steering intermediate shaft (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)>REMOVAL).
17167
13.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and heat insulator.
17104
14.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
w/ Secondary Air Injection System:
Disconnect the air fuel ratio sensor connector.
Remove the 6 nuts, manifold and gasket.
w/o Secondary Air Injection System:
Disconnect the air fuel ratio sensor connector.
Remove the 6 nuts, manifold and gasket.
89467B
15.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
17119
16.REMOVE NO. 2 MANIFOLD STAY
Remove the 3 bolts and No. 2 manifold stay.
17362
17.REMOVE NO. 2 AIR TUBE (w/ Secondary Air Injection System)
17168
18.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and heat insulator.
17105
19.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
w/ Secondary Air Injection System:
Disconnect the air fuel ratio sensor connector.
Remove the 6 nuts, manifold and gasket.
w/o Secondary Air Injection System:
Disconnect the air fuel ratio sensor connector.
Remove the 6 nuts, manifold and gasket.
89467B
20.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)