28100
1.INSTALL STARTER ASSEMBLY
Install the starter assembly with the bolt and 2 nuts.
Connect the starter wire with the nut.
Connect the starter connector.
Install the terminal cap.
51450
2.INSTALL REAR ENGINE UNDER COVER ASSEMBLY
53737A
3.INSTALL FRONT NO. 1 FENDER APRON TO FRAME SEAL LH
Install the frame seal with the 5 clips.
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).