Home › Engine / Hybrid System › 1GD-FTV (STARTING) › GLOW PLUG
RM27T0E _51 Engine / Hybrid System _053695 1GD-FTV STARTING _0260741 GLOW PLUG G

1GD-FTV STARTING  GLOW PLUG  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 19850 1.CHECK GLOW PLUG ASSEMBLY

a.

Remove the No. 1 glow plug connector (See page Engine / Hybrid System>1GD-FTV (STARTING)>GLOW PLUG>REMOVAL).


b.
A346966

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Glow plug terminal - Body ground 20°C (68°F) Approximately 1.0 Ω


If the result is not as specified, replace the glow plug assembly.

NOTICE:
·

Be careful not to damage the glow plug assemblies, as this may cause an open circuit or shorten the life of the glow plug assemblies.

·

Do not allow oil or gasoline to contact the glow plug assembly when cleaning it.

·

Clean off any oil on the terminal with a dry cloth.

·

Do not apply more than 11 V to the glow plug assembly, as this may cause an open circuit.




c.

Install the No. 1 glow plug connector (See page Engine / Hybrid System>1GD-FTV (STARTING)>GLOW PLUG>INSTALLATION).