If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while cruise control is in operation, the ECM determines there to be a momentary interruption or noise and stores a DTC.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0503 | A malfunction in the vehicle speed signal is detected while cruise control is in operation. | ·
Vehicle stability control system ·
Vehicle speed sensor signal circuit ·
Vehicle speed sensor ·
Combination meter assembly ·
ECM |
Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).
Vehicle stability control system DTCs are not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for Hydraulic Brake Booster) | B |
| NG (for Vacuum Brake Booster) | C |
A
B
C
Check the vehicle type.
| Result | Proceed to |
|---|---|
| for Gasoline Engine | A |
| for Diesel Engine | B |
A
B
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control main switch on.
Push the cruise control switch to -SET to activate cruise control.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC P0503 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1GR-FE) | B |
| NG (for 2TR-FE) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
(See pageEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
C
(See pageEngine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control man switch on.
Push the cruise control main switch to -SET to activate cruise control.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC P0503 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1KD-FTV) | B |
| NG (for 1GD-FTV) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
(See pageEngine / Hybrid System>1KD-FTV (ENGINE CONTROL)>ECD SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
C