Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1575  Warning Buzzer Malfunction  


DESCRIPTION

When the skid control ECU detects a malfunction in the skid control buzzer circuit, a malfunction signal is sent to the ECM and a DTC is stored.

DTC Code DTC Detection Condition Trouble Area
P1575 While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on, a skid control buzzer circuit malfunction signal is received from the skid control ECU for 1 second.
·

Vehicle stability control system

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

When the ECM is replaced with a new one, initialization must be performed (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>INITIALIZATION).


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Select the item below in the Active Test, and then check that the skid control buzzer sounds (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

ABS/VSC/TRC
Tester Display Test Part Control Range Diagnostic Note
Buzzer Skid control buzzer ON/OFF -

OK:

Skid control buzzer sounds.




OK

2.CHECK FOR DTC

NG

2.CHECK FOR DTC

b.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (31 mph) or more.


ii.

Turn the cruise control switch on.



c.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

DTC P1575 is not output.


Result
Result Proceed to
OK A
NG (for 1GR-FE) B
NG (for 1KD-FTV) C
NG (for 1GD-FTV) D



A

B

C

D