82125J
1.INSTALL TRANSMISSION WIRE
Coat a new O-ring with ATF and install it to the transmission wire connector.
Install the transmission wire with the bolt.
Connect the transmission wire connector.
Push up the lever until the claw of the transmission wire connector makes a connection sound.
82125J
2.CONNECT TRANSMISSION WIRE
Connect the 7 connectors to the solenoid valves.
| *1 | Orange |
| *2 | Blue |
Coat the 2 new O-rings with ATF and install them to the 2 ATF temperature sensors.
Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.
Each bolt length is indicated below.
12 mm (0.472 in.) for bolt A
36 mm (1.42 in.) for bolt B
35330
3.INSTALL VALVE BODY OIL STRAINER ASSEMBLY
Coat a new O-ring with ATF and install it to the oil strainer.
Install the oil strainer with the 4 bolts.
35106
4.INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.
Install a new gasket and the oil pan with the 20 bolts.
12371
5.INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR
51204
6.INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
Install the frame crossmember to the engine mounting insulator with the 4 set bolts.
Connect the ends of the frame crossmember to the vehicle with the 4 bolts and 4 nuts.
51225B
7.INSTALL FRONT SUSPENSION MEMBER BRACKET LH AND RH
8.ADD AUTOMATIC TRANSMISSION FLUID
Add automatic transmission fluid (See page Drivetrain>A750F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION FLUID>ADJUSTMENT).