84540
1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.
Clean the bolt and the bolt hole.
Apply adhesive to 2 or 3 threads on the end of the bolt.
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Install the park/neutral position switch assembly to the manual valve shaft.
Temporarily install the bolt.
Install a new lock washer and the nut.
| *1 | New Lock Washer |
Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.
Align the groove with the neutral basic line.
| *1 | Neutral Basic Line |
| *2 | Groove |
Hold the switch in position and tighten the bolt.
Using a screwdriver, bend the tabs of the lock washer.
Connect the park/neutral position switch connector.
2.INSPECT SHIFT LEVER POSITION
84540
3.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY