The ECM communicates with the TCM using the Controller Area Network (CAN).
If there is a problem with this communication, the TCM stores a DTC.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | All conditions are met for 1.25 seconds (1-trip detection logic):
·
Ignition switch is ON. ·
Battery voltage is 10.5 V or higher. ·
There is no communication between the ECM and TCM. |
·
Harness or connector ·
ECM ·
TCM |
Refer to the inspection procedure for the CAN communication system.
If the CAN communication malfunctions, the TCM cannot receive current data from the ECM. In this case, the freeze frame data output from the TCM has not been updated so the data will not be useful for the inspection. However, reading the Data List as the first step in troubleshooting is an effective way to find malfunctions.
The malfunctioning area can be confirmed using the Bus Check function of the intelligent tester.
for LHD with Entry and Start System: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Entry and Start System)>DIAGNOSIS SYSTEM
for LHD without Entry and Start System: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Entry and Start System)>DIAGNOSIS SYSTEM
for RHD with Entry and Start System: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Entry and Start System)>DIAGNOSIS SYSTEM
for RHD without Entry and Start System: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD without Entry and Start System)>DIAGNOSIS SYSTEM
Disconnect the C92 ECM connector.
Disconnect the G70 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C92-24 (CAN+) - G70-21 (CAN+) | Always | Below 1 Ω |
| C92-18 (CAN-) - G70-20 (CAN-) | Always | Below 1 Ω |
| C92-24 (CAN+) or G70-21 (CAN+) - Body ground or other terminals | Always | 10 kΩ or higher |
| C92-18 (CAN-) or G70-20 (CAN-) - Body ground or other terminals | Always | 10 kΩ or higher |
OK
NG
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / DTC / Clear.
Replace the TCM (See page Drivetrain>A750F (AUTOMATIC TRANSMISSION / TRANSAXLE)>TCM>REMOVAL).
Replace the TCM with the TCM of a normally functioning vehicle of the same model.
Start the engine.
Enter the following menus: Powertrain / ECT / DTC.
Read the DTCs using the intelligent tester.
| Result | Proceed to |
|---|---|
| U0100 is output | A |
| DTCs are not output | B |
A
B