1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Knee Airbag)
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67920
2.REMOVE DOOR SCUFF PLATE ASSEMBLY LH (for LHD)
67910
3.REMOVE DOOR SCUFF PLATE ASSEMBLY RH (for RHD)
62112
4.REMOVE COWL SIDE TRIM BOARD LH (for LHD)
62111C
5.REMOVE COWL SIDE TRIM BOARD RH (for RHD)
55606
6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55318C
7.REMOVE INSTRUMENT SIDE PANEL LH (for LHD)
55317A
8.REMOVE INSTRUMENT SIDE PANEL RH (for RHD)
55471A
9.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)
55476C
10.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)
55480D
11.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55045
12.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
73900
13.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
89530C
14.REMOVE TCM
Disconnect the 3 connectors.
| *A | for LHD: |
| *B | for RHD: |
Remove the 2 nuts and TCM.