Home › Drivetrain › AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH
RM27T0E _52 Drivetrain _053698 AC60F AUTOMATIC TRANSMISSION / TRANSAXLE _0260773 PARK / NEUTRAL POSITION SWITCH A

AC60F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

HINT:

Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.


a.

Clean the bolt and bolt hole.


b.

Apply adhesive to 2 or 3 threads on the end of the bolt.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



c.

Temporarily install the park/neutral position switch assembly to the automatic transmission assembly with the bolt.

HINT:

Tighten the bolt to the specified torque when adjusting the park/neutral position switch assembly.



d.

Install the lock washer and nut to the park/ neutral position switch assembly.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


e.

Move the shift lever to N.


f.
U118093E10
1.969,0.885 2.813,0.885 true 2,1.542 2.813,1.542 true 1.969,0.563 1.969,1.188 false 2.833,0.792 3,0.948 0.167,0.156 10 false *a 2.833,1.448 3,1.604 0.167,0.156 10 false *b

Align the neutral basic line with the groove as shown in the illustration, and tighten the bolt.

Torque:
13 N*m (131 kgf*cm, 9 ft.*lbf)

Text in Illustration
*a Neutral Basic Line
*b Groove


g.

Using a screwdriver, bend the tabs of the lock washer.

NOTICE:
·

Be careful not to damage the park/neutral position switch assembly.

·

Bend at least 2 of the lock washer tabs.



HINT:

Tape the screwdriver tip before use.



h.

Connect the park/neutral position switch connector.