Home › Drivetrain › AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM (for 1GR-FE)
RM27T0E _52 Drivetrain _053698 AC60F AUTOMATIC TRANSMISSION / TRANSAXLE _0260781 AUTOMATIC TRANSMISSION SYSTEM(for 1GR-FE) D

AC60F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM(for 1GR-FE)  MONITOR DRIVE PATTERN  


TEST MONITOR DRIVE PATTERN FOR ECT


CAUTION:

Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving.


HINT:

Performing this drive pattern is one method to simulate the ECM (ECT) malfunction detection conditions.

Some DTCs may not be detected through ordinary, everyday driving. Also, DTCs may not be detected through this drive pattern.


a.

Preparation for driving

i.

Warm up the engine sufficiently (engine coolant temperature is 60°C (140°F) or higher).


ii.

Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher.

Some malfunctions are not detected when the atmospheric temperature is below -10°C (14°F).



b.

Drive pattern

i.

Drive the vehicle through all the gears.

Stop → 1st → 2nd → 3rd → 4th → 5th → 6th → 6th (lock-up ON).


ii.

Perform an engine brake test with the shift lever in S. While driving in the S6 range and 6th gear lock-up, move the shift lever to "-" and down-shift from 6th → 5th, 5th → 4th, 4th → 3rd, 3rd → 2nd and 2nd → 1st.

Check that engine braking is normal for every down-shift.


iii.

Repeat the above drive pattern three times or more.

NOTICE:
·

When using the GTS, the monitor status can be checked in the Data List (See page Drivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for 1GR-FE)>DATA LIST / ACTIVE TEST).

·

In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.



C358473E01
2.302,1.802 2.646,0.417 2.646,0.417 2.844,0.417 false 4.823,2.135 5.031,1.188 5.031,1.188 5.208,1.188 false 3.219,3.104 3.479,3.583 3.479,3.583 3.667,3.583 false 1.74,2.573 2.292,3.979 2.292,3.979 2.521,3.979 false 0.281,0.49 2.271,0.688 1.99,0.198 10 false Vehicle Speed 0.021,1.313 1.177,1.896 1.156,0.583 10 false Approximately 100 km/h (62 mph) 0.094,2.073 1.177,2.635 1.083,0.563 10 false Approximately 80 km/h (50 mph) 0.323,3.406 1.885,3.688 1.563,0.281 10 false Warmed up sufficiently 1.073,2.99 2.635,3.271 1.563,0.281 10 false 0 2.646,3.917 4.542,4.313 1.896,0.396 10 false Normal acceleration through all the gears from 1st to 6th 3.792,3.51 5.354,3.792 1.563,0.281 10 false Stop (Idling) 5.333,1.115 7.052,1.427 1.719,0.313 10 false Lock-up ON Vehicle Speed 2.979,0.344 6.083,0.854 3.104,0.51 10 false Maintain a constant speed or gradual acceleration (with the throttle valve open) for 3 minutes or more.*

HINT:

*: Drive the vehicle at a speed in top gear that will cause lock-up to engage. The vehicle can be driven at a speed lower than that in the above diagram under the lock-up condition.


NOTICE:

It is necessary to drive the vehicle for approximately 30 minutes to detect DTC P0711 (No. 1 ATF temperature sensor malfunction).