31453B
1.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH
Apply MP grease to the inside of a new clevis bush.
| *1 | MP grease |
Install the clevis bush to the clutch pedal.
Install the clevis bush from the left side of the vehicle.
31301P
2.INSTALL CLUTCH PEDAL TURNOVER BUSH
Apply MP grease to the turnover bush.
| *1 | MP grease |
Install the turnover bush to the clutch pedal.
31301B
3.INSTALL NO. 1 CLUTCH PEDAL CUSHION
Install the 3 cushions to the clutch pedal.
31324A
4.INSTALL CLUTCH PEDAL SHAFT COLLAR
Apply MP grease to the shaft collar.
| *1 | MP grease |
Install the shaft collar to the clutch pedal.
31301C
5.INSTALL CLUTCH PEDAL BUSH
Apply MP grease to 2 new bushes.
| *1 | MP grease |
Install the 2 bushes to the clutch pedal.
31321
6.INSTALL CLUTCH PEDAL PAD
7.INSTALL CLUTCH PEDAL STOPPER BOLT (for 5L-E and 1GR-FE without Cruise Control)
Install the stopper bolt and temporarily install the lock nut.
Tighten the lock nut to the specified torque when adjusting the clutch pedal.
88280C
8.INSTALL CLUTCH SWITCH ASSEMBLY
Install the clutch switch and temporarily install the lock nut.
Tighten the lock nut to the specified torque when adjusting the clutch pedal.
31353
9.INSTALL CLUTCH PEDAL SPRING HOLDER
Apply MP grease to the contact surface of the spring holder.
| *1 | MP grease |
Install the spring holder.
31301
10.INSTALL CLUTCH PEDAL SUB-ASSEMBLY
Install the clutch pedal and washer to the clutch pedal support with the nut and bolt.
Install the bolt from the left side of the vehicle.
11.INSTALL TURN OVER SPRING SEAT COMPRESSION SPRING
Install the compression spring to the clutch pedal and spring holder.
31410
12.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
Install the clutch master cylinder (See page Drivetrain>CLUTCH>CLUTCH MASTER CYLINDER (for LHD)>INSTALLATION).