Use the same procedure for the RH and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.DRAIN DIFFERENTIAL OIL
43514C
3.REMOVE FRONT AXLE HUB GREASE CAP
43502H
4.REMOVE FRONT AXLE SHAFT NUT
89543
5.REMOVE FRONT SPEED SENSOR
45047
6.DISCONNECT TIE ROD END SUB-ASSEMBLY LH
48626
7.DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH
Remove the 2 bolts and disconnect the lower ball joint attachment from the steering knuckle.
43420
8.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Using SST, remove the front drive shaft.
Be careful not to damage the dust cover or oil seal.
Keep the drive shaft level while handling it.