Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43502C
1.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
Apply MP grease to a new O-ring.
Install the O-ring to the axle hub.
Install the dust cover and axle hub to the steering knuckle with the 4 bolts.
43502H
2.INSTALL FRONT AXLE SHAFT NUT
Clean the threaded parts on the drive shaft and axle shaft nut using a non-residue solvent.
Be sure to perform this work for a new drive shaft.
Keep the threaded parts free of oil and foreign objects.
Install the front axle shaft nut.
Install the adjusting cap and cotter pin.
43514C
3.INSTALL FRONT AXLE HUB GREASE CAP
Install a new axle hub grease cap.
Make sure the grease cap is securely installed to the axle hub.
43512
4.INSTALL FRONT DISC
47750
5.INSTALL DISC BRAKE CYLINDER ASSEMBLY LH
6. BLEED BRAKE LINE
for Hydraulic Brake Booster:
Bleed the brake line (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for Hydraulic Brake Booster)>BLEEDING).
for Vacuum Brake Booster:
Bleed the brake line (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for Vacuum Brake Booster)>BLEEDING).
7.CHECK FOR FLUID LEVEL IN RESERVOIR
for Hydraulic Brake Booster:
Check the brake fluid level in reservoir (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for Hydraulic Brake Booster)>ON-VEHICLE INSPECTION).
for Vacuum Brake Booster:
Check the brake fluid level in reservoir (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for Vacuum Brake Booster)>ON-VEHICLE INSPECTION).
8.CHECK FOR BRAKE FLUID LEAK
9.INSTALL FRONT WHEEL
10.ADJUST FRONT WHEEL ALIGNMENT
Adjust the front wheel alignment (See page Suspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT>ADJUSTMENT).
11.CHECK SPEED SENSOR SIGNAL
w/ VSC (for Hydraulic Brake Booster):
Inspect the speed sensor signal (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>TEST MODE PROCEDURE).
w/ VSC (for Vacuum Brake Booster):
Inspect the speed sensor signal (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>TEST MODE PROCEDURE).
w/o VSC:
Inspect the speed sensor signal (See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).