Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE › 2015.06–2020.08
RM27T0E _52 Drivetrain _053705 AXLE AND DIFFERENTIAL _0260856 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 43502C 4.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH

a.

Remove the front axle hub (See page Drivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>REMOVAL).


Hide 45047 5.DISCONNECT TIE ROD END SUB-ASSEMBLY LH

Hide 48626 6.DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH

F042737

a.

Remove the 2 bolts and disconnect the front lower ball joint attachment from the axle.


Hide 43212 7.REMOVE STEERING KNUCKLE LH

a.

Support the front suspension lower arm LH with a jack.


b.

Remove the clip and nut.


c.
F042736E07
1.927,0.76 2.719,0.167 false 2.76,0.063 3.135,0.26 0.375,0.198 10 false SST

Using SST, disconnect the upper ball joint from the steering knuckle.

SST
09628-62011  

NOTICE:

Do not the damage the ball joint dust cover.



d.

Remove the steering knuckle.