Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY (w/ Differential Lock)
RM27T0E _52 Drivetrain _053705 AXLE AND DIFFERENTIAL _0260866 REAR DIFFERENTIAL CARRIER ASSEMBLY(w/ Differential Lock) A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY(w/ Differential Lock)  INSTALLATION  


PROCEDURE

Hide 41110 1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

a.

Remove any dust and oil from the differential carrier assembly and the contact surfaces of the axle housing.


b.

Install a new gasket and the differential carrier assembly with the 11 nuts and 11 washers.

Torque:
52 N*m (530 kgf*cm, 38 ft.*lbf)


c.

Connect the differential lock actuator connector.


d.

Connect the rear differential lock actuator breather hose to the differential actuator assembly.


Hide 42312 2.INSTALL REAR AXLE SHAFT LH

a.

Install the rear axle shaft LH (See page Drivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT>INSTALLATION).


Hide 42311L 3.INSTALL REAR AXLE SHAFT RH

HINT:

Use the same procedure described for the LH side.


Hide 37110 4.INSTALL PROPELLER SHAFT ASSEMBLY

a.