Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM › 2015.06–2017.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260870 AIR SUSPENSION SYSTEM U

SUSPENSION CONTROL  AIR SUSPENSION SYSTEM  TERMINALS OF ECU  


CHECK SUSPENSION CONTROL ECU


HINT:
·

Inspect the connectors from the back side while the connectors are connected.

·

Check the operation of a particular valve by listening for an operating sound or by using the Data List.



U148187E01
2.063,0.258 2.349,0.442 0.286,0.184 10 R19 3.552,0.258 3.838,0.442 0.286,0.184 10 A14 4.996,0.258 5.282,0.442 0.286,0.184 10 A49 0.14,0.027 0.384,0.238 0.244,0.211 10 *a

Text in Illustration
*a Component with harness connected
(Suspension Control ECU)
- -

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
R19-9 (SLEX) - Body ground LG Exhaust valve Exhaust valve not operating Below 1 V
Exhaust valve operating 8 V or higher
R19-10 (GND) - Body ground W-B Ground Always Below 1 Ω
R19-13 (SBR2) - Body ground R Rear height control sensor RH power source Ignition switch ON 4.5 to 5.5 V
R19-14 (SBL2) - Body ground R Rear height control sensor LH power source Ignition switch ON 4.5 to 5.5 V
R19-15 (SGL2) - Body ground V Rear height control sensor LH ground Always Below 1 Ω
R19-16 (SGR2) - Body ground W Rear height control sensor RH ground Always Below 1 Ω
R19-22 (RC) - Body ground G AIR SUS relay Compressor motor not operating Below 1 V
Compressor motor operating 8 V or higher
R19-24 (SHRL) - Body ground GR Rear height control sensor LH Vehicle being raised Voltage increases within range of 0.5 to 4.5 V in proportion to vehicle height
Vehicle being lowered Voltage decreases within range of 0.5 to 4.5 V in proportion to vehicle height
R19-26 (SHRR) - Body ground W Rear height control sensor RH Vehicle being raised Voltage increases within range of 0.5 to 4.5 V in proportion to vehicle height
Vehicle being lowered Voltage decreases within range of 0.5 to 4.5 V in proportion to vehicle height
R19-27 (SHR2) - Body ground B Height control sensor (for AFS ECU) Vehicle being raised Voltage increases within range of 0.5 to 4.5 V in proportion to vehicle height
Vehicle being lowered Voltage decreases within range of 0.5 to 4.5 V in proportion to vehicle height
A14-9 (SBR) - Body ground G-B Front acceleration sensor RH power source Ignition switch ON 4.5 to 5.5 V
A14-10 (SGR) - Body ground L-Y Front acceleration sensor RH ground Always Below 1 Ω
A14-15 (SLRL) - Body ground L Gate solenoid valve (No. 2 height control valve) Ignition switch ON Below 1 V
Engine idling, button of height control switch is pushed from "down" to "up" 8 V or higher
A14-16 (SLRR) - Body ground V Leveling solenoid valve (No. 2 height control valve) Ignition switch ON Below 1 V
Engine idling, button of height control switch is pushed from "down" to "up" 8 V or higher
A14-17 (RM-) - Body ground G Motor lock (-) Always Below 1 Ω
A14-18 (SGFR) - Body ground R-L Front acceleration sensor RH Ignition switch ON 0.5 to 4.5 V
A14-19 (RM+) - Body ground P Motor lock (+) Engine idling, vehicle height changes from N to HI by pressing height control switch (While height control compressor assembly operating) Below 1 V
A14-21 (SGL) - Body ground W Height control sensor ground (for AFS ECU) Always Below 1 Ω
A14-22 (SBL) - Body ground R-G Height control sensor power source (for AFS ECU) Ignition switch ON 4.5 to 5.5 V
A49-1 (IG) - Body ground B IG power supply Ignition switch ON 11 to 14 V
A49-3 (B) - Body ground GR Battery power supply Always 11 to 14 V
A49-5 (GND) - Body ground W-B Ground Always Below 1 Ω
A49-7 (CANH) - A49-8 (CANL) R*1 - W CAN communication line Ignition switch off 54 to 69 Ω
GR*2 - W
A49-13 (TD) - Body ground L Height control OFF switch
·

Ignition switch ON

·

Switch pressed and held


11 to 14 V
·

Ignition switch ON

·

Switch not pressed


Below 1 V
A49-14 (DNSW) - Body ground V Height control switch "down" side
·

Ignition switch ON

·

Switch pressed and held


11 to 14 V
·

Ignition switch ON

·

Switch not pressed


Below 1 V
A49-15 (UPSW) - Body ground P Height control switch "up" side
·

Ignition switch ON

·

Switch pressed and held


11 to 14 V
·

Ignition switch ON

·

Switch not pressed


Below 1 V
A49-16 (SGR3) - Body ground R Rear acceleration sensor ground Always Below 1 Ω
A49-17 (SBR3) - Body ground W Rear acceleration sensor power source Ignition switch ON 4.5 to 5.5 V
A49-22 (TSW2) - Body ground B Absorber control switch (COMF)
·

Ignition switch ON

·

Absorber control switch set to NORMAL


10 to 14 V
·

Ignition switch ON

·

Absorber control switch set to COMF


Below 1.5 V
A49-23 (TSW1) - Body ground G Absorber control switch (SPORT)
·

Ignition switch ON

·

Absorber control switch set to NORMAL


10 to 14 V
·

Ignition switch ON

·

Absorber control switch set to SPORT


Below 1.5 V
A49-26 (SGRR) - Body ground LG Rear acceleration sensor Ignition switch ON 0.5 to 4.5 V

*1: for RHD

*2: for LHD