SUSPENSION CONTROL
AIR SUSPENSION SYSTEM
- PRECAUTION
- PARTS LOCATION2015.06–2017.082017.08–2020.08from 2020.08
- SYSTEM DIAGRAM2015.06–2017.082017.08–2020.08from 2020.08
- SYSTEM DESCRIPTION2015.06–2020.08from 2020.08
- HOW TO PROCEED WITH TROUBLESHOOTING2015.06–2017.08from 2017.08
- REGISTRATION2015.06–2017.082017.08–2020.08from 2020.08
- TEST MODE PROCEDURE2015.06–2017.082017.08–2020.08from 2020.08
- PROBLEM SYMPTOMS TABLE2015.06–2017.08from 2017.08
- TERMINALS OF ECU2015.06–2017.082017.08–2020.08from 2020.08
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR2015.06–2017.08from 2017.08
- FAIL-SAFE CHART2015.06–2017.08from 2017.08
- DATA LIST / ACTIVE TEST2015.06–2017.082017.08–2020.08from 2020.08
- DIAGNOSTIC TROUBLE CODE CHART2015.06–2017.082017.08–2020.08from 2020.08
- ON-VEHICLE INSPECTION
- C1713, C1714 from 2017.08
- C1713/13, C1714/14 2015.06–2017.08
- C1715, C1716, C1717, C1796, C1797, C1798 from 2017.08
- C1715/15, C1716/16, C1717/17, C1796/96, C1797/97, C1798/98 2015.06–2017.08
- C1731, C1732, C1733, C1734 from 2017.08
- C1731/31, C1732/32, C1733/33, C1734/34 2015.06–2017.08
- C1745 Either condition is met: · With the exhaust solenoid valve not activated, an open signal of the exhaust... from 2017.08
- C1745/45 Either condition is met: · With the exhaust solenoid valve not activated, an open signal of the exhaust... 2015.06–2017.08
- C1746 Either condition is met: · With the height control valve inactivated, an open signal of the height control... from 2017.08
- C1746/46 Either condition is met: · With the height control valve inactivated, an open signal of the height control... 2015.06–2017.08
- C1747 Either condition is met: · With the height control valve inactivated, an open signal of the height control... from 2017.08
- C1747/47 Either condition is met: · With the height control valve inactivated, an open signal of the height control... 2015.06–2017.08
- C1751 Either condition is met: · With the AIR SUS relay inactivated, an open signal of the AIR SUS relay is... from 2017.08
- C1751/51 Either condition is met: · With the AIR SUS relay inactivated, an open signal of the AIR SUS relay is... 2015.06–2017.08
- C1752 With the AIR SUS relay activated, a lock signal of the height control compressor motor is detected for 4... from 2017.08
- C1752/52 With the AIR SUS relay activated, a lock signal of the height control compressor motor is detected for 4... 2015.06–2017.08
- C1761 Either condition is met a total of 2 times or more with the ignition switch ON: · Power is continuously... from 2017.08
- C1761/61 Either condition is met a total of 2 times or more with the ignition switch ON: · Power is continuously... 2015.06–2017.08
- C1762 With the exhaust solenoid valve activated, the vehicle height is not lowered to the standard vehicle height... from 2017.08
- C1762/62 With the exhaust solenoid valve activated, the vehicle height is not lowered to the standard vehicle height... 2015.06–2017.08
- C1781 One of the following conditions is met: · A nonvolatile memory malfunction · A CAN communication resistor... from 2017.08
- C1781/81 One of the following conditions is met: · A nonvolatile memory malfunction · A CAN communication resistor... 2015.06–2017.08
- C1782 The voltage at terminal IG or B is 10 V or less or 16 V or higher for 0.5 seconds. from 2017.08
- C1782/82 The voltage at terminal IG or B is 10 V or less or 16 V or higher for 0.5 seconds. 2015.06–2017.08
- C1783 A speed sensor malfunction signal from the skid control ECU is detected for 1 second. from 2017.08
- C1783/83 A speed sensor malfunction signal from the skid control ECU is detected for 1 second. 2015.06–2017.08
- C1784 A steering sensor signal malfunction is detected, or a steering sensor power source malfunction signal is... from 2017.08
- C1784/84 A steering angle sensor signal malfunction is detected, or a steering angle sensor power source malfunction... 2015.06–2017.08
- C1787 While the ignition switch is ON, a yaw rate and acceleration sensor malfunction signal is detected for 1... from 2017.08
- C1787/87 While the ignition switch is ON, a yaw rate and acceleration sensor malfunction signal is detected for 1... 2015.06–2017.08
- C1789 One of the following conditions is met: · The vehicle identification information is not stored. · Vehicle...2017.08–2020.08from 2020.08
- C1789/89 Either condition is met: · The vehicle identification information is not stored. · The information stored in... 2015.06–2017.08
- C1791 The absorber control switch signal does not change. 2017.08–2020.08
- C1791/91 The absorber control switch signal does not change. 2015.06–2017.08
- C1792 The height control switch signal does not change. from 2017.08
- C1792/92 The height control switch signal does not change. 2015.06–2017.08
- C1794 Stored only during test mode. from 2017.08
- C1794/94 Stored only during test mode. 2015.06–2017.08
- U0100, U0114, U0122, U0124, U0126, U0140 from 2017.08
- U0100/71, U0114/71, U0122/71, U0124/71, U0126/71, U0140/71 2015.06–2017.08
KINETIC DYNAMIC SUSPENSION SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM2015.06–2017.082017.08–2020.082020.08–2021.06from 2021.06
- SYSTEM DESCRIPTION2015.06–2017.08from 2017.08
- HOW TO PROCEED WITH TROUBLESHOOTING2015.06–2017.08from 2017.08
- PROBLEM SYMPTOMS TABLE2015.06–2017.082017.08–2021.06from 2021.06
- TERMINALS OF ECU2015.06–2020.08from 2020.08
- DIAGNOSIS SYSTEM2015.06–2021.06from 2021.06
- DTC CHECK / CLEAR2015.06–2020.082020.08–2021.06from 2021.06
- FAIL-SAFE CHART2015.06–2017.08from 2017.08
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART2015.06–2017.082017.08–2021.06from 2021.06
- ON-VEHICLE INSPECTION
- C1812 One of the following conditions continues is met: · The sensor power source voltage (SBP1 terminal) is 4.3 V... from 2021.06
- C1812/12 One of the following conditions continues is met: · The sensor power source voltage (SBP1 terminal) is 4.3 V...2015.06–2020.082020.08–2021.06
- C1831, C1832 from 2021.06
- C1831/31, C1832/322015.06–2017.082017.08–2021.06
- C1851, C1853 from 2021.06
- C1851/51, C1853/53 2015.06–2021.06
- C1879 A signal indicating that the yaw rate and acceleration sensor zero point calibration has not been performed... from 2021.06
- C1879/79 A signal indicating that the yaw rate and acceleration sensor zero point calibration has not been performed... 2015.06–2021.06
- C1881 Either condition is met: · A nonvolatile memory error occurs. · A malfunction occurs in the message register... from 2021.06
- C1881/81 Either condition is met: · A nonvolatile memory error occurs. · A malfunction occurs in the message register... 2015.06–2021.06
- C1882 The IG terminal voltage is 10 V or less or 16 V or higher for 0.5 seconds from 2021.06
- C1882/82 The IG terminal voltage is 10 V or less or 16 V or higher for 0.5 seconds 2015.06–2021.06
- C1883 The stabilizer control ECU continuously receives a speed sensor malfunction signal from the skid control ECU... from 2021.06
- C1883/83 The stabilizer control ECU continuously receives a speed sensor malfunction signal from the skid control ECU... 2015.06–2021.06
- C1884 Either condition is met: · The stabilizer control ECU receives an error signal from the steering sensor for 5... from 2021.06
- C1884/84 Either condition is met: · The stabilizer control ECU receives an error signal from the steering sensor for 5...2015.06–2017.082017.08–2021.06
- C1887 The stabilizer control ECU receives an error signal from the yaw rate and acceleration sensor for 1 second. from 2021.06
- C1887/87 The stabilizer control ECU receives an error signal from the yaw rate and acceleration sensor for 1 second. 2015.06–2021.06
- U0100, U0122, U0124, U0126 from 2021.06
- U0100/71, U0122/71, U0124/71, U0126/712015.06–2017.082017.08–2021.06
SUSPENSION CONTROL SYSTEM (w/ Air Suspension)
SUSPENSION CONTROL SYSTEM (w/ KDSS)
HEIGHT CONTROL COMPRESSOR
HEIGHT CONTROL DRYER
CONTROL VALVE ASSEMBLY
STABILIZER CONTROL VALVE(w/ KDSS)
STABILIZER CONTROL TUBE (w/ KDSS)
HEIGHT CONTROL SENSOR
SUSPENSION CONTROL ECU
STABILIZER CONTROL ECU
FRONT ACCELERATION SENSOR
REAR ACCELERATION SENSOR
ABSORBER CONTROL ACTUATOR
ABSORBER CONTROL SWITCH
HEIGHT CONTROL OFF SWITCH
HEIGHT CONTROL SWITCH