Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM › 2015.06–2017.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260870 AIR SUSPENSION SYSTEM M

SUSPENSION CONTROL  AIR SUSPENSION SYSTEM  REGISTRATION  


CAUTION / NOTICE / HINT

NOTICE:
·

CAN communication system must be functioning normally.

·

Make sure that the ECM is the correct type, normally functioning and correctly installed.



HINT:
·

If the suspension control ECU is replaced with a new one, perform registration of vehicle identification information.

·

Vehicle identification information is obtained automatically through CAN communication when in test mode.



PROCEDURE

Hide 1.REGISTRATION OF VEHICLE IDENTIFICATION INFORMATION (WHEN USING INTELLIGENT TESTER)

a.

Turn the ignition switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the intelligent tester on.


e.

Enter the following menus: Chassis / Air suspension / Utility / Signal Check.


f.

Check the display of the multi-information display and confirm that the system is in test mode.

HINT:
·

When the vehicle identification information is stored, the multi-information display indicates that the system is in test mode.

·

When vehicle identification information is not stored, the height control OFF indicator blinks at 1 second intervals (1 second on and 1 second off).




Hide 2.REGISTRATION OF VEHICLE IDENTIFICATION INFORMATION (WHEN USING SST CHECK WIRE)

a.

Turn the ignition switch off.


b.
U115770E01
0.108,0.087 0.413,0.237 0.304,0.151 10 *a 2.137,0.207 2.441,0.358 0.304,0.151 10 CG 0.933,1.943 1.238,2.094 0.304,0.151 10 TS

Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Do not connect the incorrect terminals as this will cause damage.


Text in Illustration
*a Front view of DLC3


c.

Turn the ignition switch to ON.


d.

Check the display of the multi-information display and confirm that the system is in test mode.

HINT:
·

When the vehicle identification information is stored, the multi-information display indicates that the system is in test mode.

·

When vehicle identification information is not stored, the height control OFF indicator blinks at 1 second intervals (1 second on and 1 second off).