| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100/71 | While driving at 30 km/h (19 mph), the ECM informs of a CAN communication stop for 3 seconds or more. | CAN communication system |
| U0114/71 | The four wheel drive control ECU informs of a CAN communication stop for 3 seconds or more. | |
| U0122/71 | The skid control ECU informs of a CAN communication stop for 3 seconds or more. | |
| U0124/71 | The yaw rate and acceleration sensor informs of a CAN communication stop for 3 seconds or more. | |
| U0126/71 | The steering angle sensor informs of a CAN communication stop for 3 seconds or more. | |
| U0140/71 | The main body ECU informs of a CAN communication stop for 10 seconds or more. |
When DTCs indicating a CAN communication system malfunction are output, repair CAN communication system first.
Clear the DTCs (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).
Perform a road test.
Check for DTCs (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (for LHD) | B |
| DTC is output (for RHD) | C |
If a CAN communication malfunction DTC and a related sensor malfunction DTC are output at the same time, the CAN communication malfunction must be repaired before troubleshooting the sensor malfunction DTC.
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C